These white Vinyl Decals really dress up your auto and show your softball spirit!

Approx. 3" X 7" in size, see installation instructions below.

 Decal Installation Instructions:

 Vinyl decals will stick to about any clean smooth surface. Make sure it is free of dirt, wax and grease. We recommend installation temp. of surface between 40 - 90 degrees. Tools to have on hand for install - tape measure, pencil, paper tows, scissors, masking tape, Windex or alcohol, squeegee or credit card. Note: Have your scissors and squeegee within reach. Start separating the decal from the backing paper slowly making sure all of the decal stays on the application paper. Lay the decal back making sure not to stick it to anything. Cut the backing paper off as close to the center tap as you can.

Now take your proper aligned decal and remove the small piece of tape from one end.

Holding the decals in your left hand. Use the squeegee in your right hand and starting from the center tape, work the decal down and outward evenly forcing out any air bubbles. As shown in this picture.

Now remove both other pieces of masking tape and Repeat step 2. The left side of the decal will now hold it in position.

Now that the entire decal is on the surface and squeegeed down. Start at one end and begin removing the application tape, pulling it back at a 45 degree angle slowly making sure the decal stays on the surface. If you have any air bubbles left in decal. Use a pin to poke little holes in them and force the air out.

Do not directly power wash decals or scrape with ice scraper. Windshield wipers will not hurt these decals.